What should be noted when choosing brush coating as the painting method?
During the construction process, if brushing is chosen as the coating method, the following points should be noted:
When brushing, the steps of the paintbrush dipping the paint, applying it, smoothing it out and finishing it should be continuous without any pauses or gaps.
When performing coating and smoothing operations, the paintbrush should be in a vertical position and most of the bristles should be firmly attached to the surface of the object to be coated. However, when trimming, the paintbrush should be tilted towards the running direction, and the front end of the bristles should be used to gently brush and trim.
The three steps of coating, smoothing and finishing should be brushed in a crisscross pattern. However, for the vertical surface of the object to be coated, the last step should be brushed vertically along the vertical direction.
It is best to keep the amount of paint adhered by the brush each time basically consistent. As long as the brush is properly selected, the area of paint applied by the brush each time can also remain basically consistent.
When brushing a large area of the object to be painted, it is usually advisable to start from the upper left corner. After each application of paint, follow the three steps of coating, smoothing and finishing to complete the brushing area of one piece, and then apply the next piece of paint.
When brushing on the back, the paintbrush should adhere less to the paint. Do not apply too much force when brushing and do not run the paintbrush too fast to prevent the paint from falling off.
When brushing, the steps of the paintbrush dipping the paint, applying it, smoothing it out and finishing it should be continuous without any pauses or gaps.
When performing coating and smoothing operations, the paintbrush should be in a vertical position and most of the bristles should be firmly attached to the surface of the object to be coated. However, when trimming, the paintbrush should be tilted towards the running direction, and the front end of the bristles should be used to gently brush and trim.
The three steps of coating, smoothing and finishing should be brushed in a crisscross pattern. However, for the vertical surface of the object to be coated, the last step should be brushed vertically along the vertical direction.
It is best to keep the amount of paint adhered by the brush each time basically consistent. As long as the brush is properly selected, the area of paint applied by the brush each time can also remain basically consistent.
When brushing a large area of the object to be painted, it is usually advisable to start from the upper left corner. After each application of paint, follow the three steps of coating, smoothing and finishing to complete the brushing area of one piece, and then apply the next piece of paint.
When brushing on the back, the paintbrush should adhere less to the paint. Do not apply too much force when brushing and do not run the paintbrush too fast to prevent the paint from falling off.